type is highlighted in reverse video use the � or � buttons i to select the source you wish to listen to or view. Remember that the video source should be selected first when you wish to watch one source and listen to another. To select a digital audio input use the � or ¤ buttons i to position the onscreen cursor > next to DIGITAL. Press Select j and note that the word DIGITAL will be highlighted in reverse video. Then use the � or � buttons i to select the desired digital source. Note that when any digital source is selected, the audio source will indicate **. You may also use this menu to turn the attenuation, or ATT, function on or off for a source by moving the cursor to the ATT line and using the � or � buttons i to select ON or OFF When the ATT . function is enabled the input level is reduced to prevent overloading the input circuits.
SURROUND MODE: At this menu (see figure #15) you may change the surround mode by using the � or ¤ buttons i to position the on-screen cursor > next to MODE and using the � or � buttons i to select the desired mode. To change the delay time position the cursor next to SURROUND CH and then use the � or � buttons i to select desired delay time for the surround channels. Note that an adjustment for the delay time of the center channel is possible only in the Dolby Digital mode. TEST TONE: At this menu you
using the Setup menus, refer to the System Configuration section of this manual.
SLEEP TIMER SET: This enables you
SURROUND MODE :PRO
MODE LOGIC
DELAY TIME CONTROL CENTER CH :NONE SURROUND CH :2ms
to set the sleep timer, which will place the unit in a standby mode after a set period of time. To reach this menu, press the � or ¤ buttons i to position the onscreen cursor > next to SLEEP TIMER and press Select j. At the next screen, the SLEEP TIMER SET menu (see fi gure #16) the cursor will be next to TIMER SET. Use the � or � buttons i to select the amount of time before turn off and note that the time will blink. Press the ¤ button so that the on-screen cursor > is next to TIMER OFF ON. Use the � or � buttons i to highlight ON and press Select j. The time figure will stop flashing indicating that the timer has been started. Press ¤ one more time so that the cursor is next to RETURN TO MAIN MENU and press Select j. Note that when the MAIN MENU returns to the screen the time figure will appear next to the words SLEEP TIMER. You may check the time remaining before shut off at any time by pressing the Sleep button z on the remote and viewing the front panel or on-screen display (see figure #12). Position the on-screen cursor > next to MENU OFF at any time to exit the menu system and return to normal operation.
RETURN
TO
MAIN
MENU
Figure 15
SLEEP TIMER TIMER
TIMER SET OFF
SET 10min ON
RETURN
TO
MAIN
MENU
Figure 16
may adjust the front and surround speaker output levels. For information on this procedure, refer to the System Configuration section of this manual.
